Hello Andrew,
but I cannot find a way to do it. I have a solid line across the plan with a arrows on, but cannot get it to hide the bit in the middle.
Section lines work a little differently than regular lines. When you place the line, make it a bezier curve and place the control handle that you use to bend the line around next to the spot where you want it to disappear. Do that on both ends of the line. The line isn't *actually* a bezier curve, even though it's constructed the same way as one. It just uses the handles to determine where you want the section line to be hidden.
On the section line, all the other direction options work but I cannot figure out -direction point
Try "-direction end" and "-direction begin" ("start" maybe, i haven't looked in the manual) instead. That will make the arrow appear on the respective end of the line. You may have to hit reverse and then switch the direction if the arrow points the wrong way. Rember, the -direction should be specified in the "options" area of the section line. Hopefully this helps. -Jonny ^v^