[Therion] join command

[Boldt, Markus]

Hi Martin, Thank you very much! 
It must as stupid wuestions for you as one of the Developers of Therion. 
Insofar excuse me - but I have looked for that problem in the conference before putting this question on the list. May be not good enough. 

Markus



-----Ursprüngliche Nachricht-----
Von: therion-bounces at speleo.sk [mailto:therion-bounces at speleo.sk] Im Auftrag von Martin Sluka
Gesendet: Mittwoch, 11. März 2009 19:28
An: List for Therion users
Betreff: Re: [Therion] join command


On 11.3.2009, at 18:57, Boldt, Markus wrote:

> I have a survey on a level of about 500m given in one scrap.  
> Another scrap (in the same File) contains a short passage with about 
> 550m. The two scraps are connected at one station point. But Therion 
> writes a map so that the higher "level" is below the lower.
> What is wrong?

If you define the map you should write scraps in order from top to bottom (if they one above other). And if they are overlaped you should use "break". There are several other ways how to define what is up and what is down - check the conference.

m.
_______________________________________________
Therion mailing list
Therion at speleo.sk
http://mailman.speleo.sk/mailman/listinfo/therion