[Therion] join command

[Martin Sluka]

On 11.3.2009, at 18:03, Boldt, Markus wrote:

> Hello,
> in one case the "join" command doesn`t works on my computer.
> Version Therion 5.2.7
> I have two scraps in one *.th2-file. There are only two lines (type  
> wall) in that second scrap.
> So I have, like described in TB, given IDs to that two lines and to  
> two other lines in the first scrap.
> Then I have written this command line in my *.th-file after  
> "endcenterline"-command.
> join VH10_L1 at VH10:0 VH10_L3 at VH10:0
> It gives a "survey does not exist -- VH10" error. If I comment out  
> the line it works without a problem.
> The map is written but the lines resp. the points of the lines are  
> not connected. And that was it, what I wanted to do.
>
> Where is the fault, which I make?
>
> survey does not exist -- VH10
>
It means therion doesn't know the scrap VH10 in the level you use the  
join

Have you input your .th2_file in survey where is the join?

But in that case the craps will be in the same level as join, so you  
should use:

  "join VH10_L1:0 VH10_L3:0" instead.

m.s.