Thank you for the fadt reply. If i understand and interpret correctly, the behavior unfolds in the following way: - when i detect inproper morphing of walls compared to lrud data - i place "extra" points on my traced wall signature. - the extra point position is approximately where the lrud point is assumed to be on the wall. - when rendering, therion morphes the wall to match the extra point position to the corresponding lrud position for that point (which is the nearest station). That would imply: a) there is no use for extra points without lrud data. b) extra points reference l+r positions of lrud data of the nearest station, therefore it is not possible to set more than two extra points per station. Is the above true? Am 2016-11-18 11:20, schrieb Martin Sluka:
18. 11. 2016 v 8:07, Benedikt Hallinger <beni@hallinger.org>:
Hello, i struggle to understand how the extra morphing points are meant to be used.
How do they work technically? How do i correctly set them? Are they linked to the nearest station and could i use more than two extra points? Are they linked to LRUD data?
I already investigated the "morohing" example from the documentation (both in code and in thbook), so i think it would be good to stick to this example.
Thank you very much! _______________________________________________ Therion mailing list Therion@speleo.sk https://mailman.speleo.sk/listinfo/therion
Hi Benedikt,
the purpose of these extra points is to correct differences between LRUD data (if available) and distances to walls in sketches.
Check page 89 of TherionBook.
m.
_______________________________________________ Therion mailing list Therion@speleo.sk https://mailman.speleo.sk/listinfo/therion