[Therion] Placing part of a map below another

[Martin Sluka]

Break will not work in map definition from maps. Only sequence of particular maps works. 

Martin

Odesláno z iPhonu

26. 7. 2019 v 18:46, Tarquin Wilton-Jones via Therion <therion at speleo.sk>:

> Hi Bill,
> 
>> When I set up the map in the .th file, I created a map for "MainPassages" and another for "LowerStream".
> 
> 
> You don't normally need to do this. You can just put the two scraps into
> the same map like this:
> 
> map outermap
>  mainpassagesscrap
>  break
>  lowerstreamscrap
> endmap
> 
> This will display the lower stream's scrap below the main passages
> scrap. Or if you want to keep your two maps, then this should work:
> 
> map outermap
>  MainPassages
>  break
>  LowerStream
> endmap
> 
> Make sure your .thconfig file has:
> 
> select outermap at surveyname
> 
> I think this is the most likely cause of your problem - if you don't
> select the right map, Therion will select all of the scraps, without any
> control over stacking order.
> 
>> "[0 0] below"
> 
> 
> This is something very different, and not related to stacking order. It
> is used to offset a map from its natural position, and leave a shadow
> "below" the other maps where it would normally have been. "0 0" would
> not offset it at all, so you are asking Therion to draw the map in its
> natural position, and leave a shadow ... also in its natural position
> ... below the map.
> 
> Probably not what you were looking for :)
> 
> Hope this is useful.
> 
> Tarquin
> _______________________________________________
> Therion mailing list
> Therion at speleo.sk
> https://mailman.speleo.sk/listinfo/therion