[Therion] Placing part of a map below another

[Torsten Schnitter]

Hm... maybe changing the sequence of the two maps !?

Torsten

> Am 26.07.2019 um 17:07 schrieb Bill Gee <bgee at campercaver.net>:
> 
> Hello everyone -
> 
> I seem to be missing something.  I have made this work in the past, but now it seems that Therion is totally ignoring my instructions.  Argh!
> 
> I have a part of the cave where a stream flow under a tourist trail overlook.  The original sketches were done on two different occasions, and I have drawn them as separate scraps.
> 
> When I set up the map in the .th file, I created a map for "MainPassages" and another for "LowerStream".  These are then collected into a single map.  The LowerStream map has options "[0 0] below".  However, the compiled map always shows it ABOVE.
> 
> I tried adding a "break" between the two maps.  I tried adding units to the [0 0], and I tried changing the offset from [0 0] to [20 20].  None of these made any visible difference in the compiled map.  I tried removing the "join" that connects the lower stream to the main passage, but all that did was make for a sloppy join.  The lower stream was still above the overlook area.
> 
> I have other caves where I have done this, and it worked.  What am I missing?
> 
> Attached is the .th file I am using.
> 
> Thanks!
> 
> -- 
> Bill Gee
> 
> <StarkCaverns.th>
> _______________________________________________
> Therion mailing list
> Therion at speleo.sk
> https://mailman.speleo.sk/listinfo/therion