[Therion] how to do multilevel scrap

[Martin Sluka]

There are two very strange things in your scraps:

1. the pillar (hole in the map) should have wall -outline in . It is  
strange it works without it in your case, but correct is add option - 
outine in

2. you drew two scraps from two separated parts (20101106_2_p1,  
20101106_4_p1. Correct way is to name each part as separate scrap.  
Very important it is in second case where each part belong to  
different level.

If there are two levels you should write in map:

above_scrap
break
below_scrap

Martin


On 19.8.2011, at 20:23, Will Urbanski wrote:

> Hello everyone,
>
> I am trying to do a multilevel map in Therion and for some reason i  
> can't figure out how to get dashed wall lines to appear. Attached is  
> a screenshot of my area in question. There is a plumb shot from a60  
> to a67, and that's where the confusion starts. a67+ should all be  
> below, and even though this data is in therion, it does not seem to  
> understand that. Is there a directive I should be using to  
> accomplish this?
>
> Thanks in advance!!!!
>
> Will
>
> -- 
> Will Urbanski
>
>
> <therion- 
> funkyfloor 
> .png><ddc.tgz>_______________________________________________
> Therion mailing list
> Therion at speleo.sk
> http://mailman.speleo.sk/mailman/listinfo/therion