[Therion] x-section lines

[Jonny Prouty]

Hello Andrew,

> but I cannot find a way to do it. I have
> a solid line across the plan with a arrows on, but cannot get it to hide the
> bit in the middle.

Section lines work a little differently than regular lines. When you
place the line, make it a bezier curve and place the control handle
that you use to bend the line around next to the spot where you want
it to disappear. Do that on both ends of the line. The line isn't
*actually* a bezier curve, even though it's constructed the same way
as one. It just uses the handles to determine where you want the
section line to be hidden.

> On the section line, all the other direction options work but I cannot
> figure out
> -direction point

Try "-direction end" and "-direction begin" ("start" maybe, i haven't
looked in the manual) instead. That will make the arrow appear on the
respective end of the line. You may have to hit reverse and then
switch the direction if the arrow points the wrong way. Rember, the
-direction should be specified in the "options" area of the section
line.

Hopefully this helps.

-Jonny ^v^