Hi all

The area of one of my scans (actually a composite of multiple scan files) exceeds the area of the ‘white space’ in the drawing editor, and at 100% zoom and greater I cannot always access this outer area for drawing.  (I have not experimented too much, because I think one of you will be able to answer this easily)

I have a very complex, single layer, part of a cave that is surrounded by about five simple passages that intersect it, so I want it to be one scrap.  Are there any restrictions on drawing outside the ‘white space’ other that not being able to view it at higher magnifications?  For example, will Therion clip the scrap to these borders?

And if there is a problem, what is the best solution(s)?

            Two or more scraps?

            Scan at lower resolution?

            Stitch scans together before loading into the drawing editor?

            Other ideas?

Regards

Bruce Mutton