Pozri si v Samples: Extended elevation control Z therionbooku: centerline: extend <spec> [<station> [<station>]] . control how the centerline is extended. <spec> is one of the following: normal/reverse - extend given and following stations to the same/ reverse direction as previous station. If two stations are given| direction is applied only to given shot. left/right - same as above, but direction is speci ed explicitly. vertical - do not move station (shot) in X direction, use only Z component of the shot start - specify starting station (shot) ignore - ignore speci ed station (shot), continue extended elevation with other station (shot) if possible hide - do not show speci ed station (shot) in extended elevation If no stations are speci ed, <spec> is valid for following shots speci ed. On 29.4.2010, at 11:58, Michal Danko wrote:

Ahojte, Zacal som sa ucit robit rez jaskynou, cez "extend left/right" som si upravil tah zhruba tak ako by som si prial len jednu vetvu by som potreboval odsadit podobne ako na prilozenom obrazku.

odsadenie/offset co som cital v thbooku je definovane iba pri scrapoch, pre cisty pol. tah som nic nenasiel. je mozne to nejako podobne aplikovat pre cisty pol tah ? alebo treba nakreslit mapu a potom definovat skupiny scrapov ) na offset?

Ing. Michal Danko ------------------------------ www.speleonicolaus.sk icq 143748429 skype:dankez <javorova_vyrez.jpg>_______________________________________________ Therion-cs mailing list Therion-cs@speleo.sk http://mailman.speleo.sk/mailman/listinfo/therion-cs